Adaptive station Aquarobot qb 60. Pumping stations “Aquarobot qb. Advantages of the automatic adaptive station aquarobot

Adaptive automatic pumping station AQUAROBOT QB series— with a 2 or 5 l hydraulic accumulator designed to supply clean water, which does not contain abrasive particles and fibrous inclusions, from shallow wells, wells and other water supply sources in automatic mode(turning on and off as the consumer consumes water). The stations are equipped electronic unit, which controls the operation of the pump in terms of flow and minimum pressure (Pmin), and also protects the pump from operation in “dry running” mode and other emergency situations(drop in mains voltage, incorrect installation, etc.).

Advantages of the automatic adaptive station AQUAROBOT

• Automatically turns off when there is no water in the water supply system.
• Automatically switches off when the pump impeller becomes jammed.
• Operates stably when the mains voltage drops to 120 V.
• Automatically turns off if there is no air pressure in the accumulator.
• Automatically turns off when water leaks from the water supply system, if the flow rate is no more than 2 l/min.
• Adaptively maintains pressure in the water supply system, which significantly increases the service life of the pump.
• Operates stably at a critical suction depth of 8 meters.
• It automatically turns off if the station is incorrectly connected to the water supply source (for stable operation at low voltage or a critical suction depth of 8 meters, the water flow rate must be more than 2 l/min).

The principle of operation of the station is that when a water flow passes through the control unit at a speed above 2 l/min, or when the pressure drops below Pmin (1.5±0.3 bar), the pump turns on and pumps water continuously, creating pressure, the value of which depends on the pump parameters. When the water flow stops or its speed decreases to 2 l/min, the pump automatically turns off with a thirty-second delay.

AQUAROBOT ensures reliable shutdown of the station

• In low well productivity mode (“dry run”)
• If there is no air in the accumulator (no pressure)
• When the water flow is below 2 liters per minute (line leakage)
• In the mode of dynamic fluctuation of the water level in the well below 8 meters
• In case of improper installation of equipment and water supply lines

In the event of an emergency shutdown of the pumping station, it is necessary to eliminate the cause and restart it.

Attention. The use of the station in pressure boosting systems is not allowed if the pressure created by the pump, combined with the main pressure, is higher than or close to 6 bar.

Adaptive automatic pumping station AQUAROBOT QB 60 2l.- with a 2-liter hydraulic accumulator, designed to supply clean water that does not contain abrasive particles and fibrous inclusions from shallow wells, wells and other water supply sources in automatic mode (turning on and off as the consumer consumes water). The stations are equipped with an electronic unit that controls the operation of the pump in terms of flow and minimum pressure (Pmin), and also protects the pump from operation in “dry running” mode and other emergency situations (drop in mains voltage, improper installation, etc.).

Advantages of the automatic adaptive station AQUAROBOT QB 60 2l.

• Automatically turns off when there is no water in the water supply system.
• Automatically switches off when the pump impeller becomes jammed.
• Operates stably when the mains voltage drops to 120 V.
• Automatically turns off if there is no air pressure in the accumulator.
• Automatically turns off when water leaks from the water supply system, if the flow rate is no more than 2 l/min.
• Adaptively maintains pressure in the water supply system, which significantly increases the service life of the pump.
• Operates stably at a critical suction depth of 8 meters.
• It automatically turns off if the station is incorrectly connected to the water supply source (for stable operation at low voltage or a critical suction depth of 8 meters, the water flow rate must be more than 2 l/min).

The principle of operation of the station is that when a water flow passes through the control unit at a speed above 2 l/min, or when the pressure drops below Pmin (1.5±0.3 bar), the pump turns on and pumps water continuously, creating pressure, the value of which depends on the pump parameters. When the water flow stops or its speed decreases to 2 l/min, the pump automatically turns off with a thirty-second delay.

AQUAROBOT QB 60 2l. provides reliable shutdown stations

• In low well productivity mode (“dry run”)
• If there is no air in the accumulator (no pressure)
• When the water flow is below 2 liters per minute (line leakage)
• In the mode of dynamic fluctuation of the water level in the well below 8 meters
• In case of improper installation of equipment and water supply lines

In the event of an emergency shutdown of the pumping station, it is necessary to eliminate the cause and restart it.

Attention. The use of the station in pressure boosting systems is not allowed if the pressure created by the pump, combined with the main pressure, is higher than or close to 6 bar.

Technical information

• Options electrical network– ~220 V ± 10%, 50 Hz
• Suction height – 8 m (for AQUAROBOT JET, JS) / 5 m (for AQUAROBOT QB)
• Operating water temperature range – +1 … +35°С, at temperature environment+1 … +40°С and air humidity no more than 70%.
• Connecting dimensions: 1″ external thread x 1″ internal thread
• Pressure compressed air in the hydraulic accumulator – 0.15 MPa (1.5 bar)
• Maximum permissible pressure in the system – 6 bar
• Pump activation pressure Pmin – 1.5±0.3 bar
• The minimum sensitivity of the flow sensor is 2 l/min.

Pressure and flow characteristics

Contents of delivery:

• Automatic water supply station assembly – 1 pc.
• Operating manual – 1 pc.
• Packaging – 1 pc.

Adaptive automatic pumping station AQUAROBOT QB series- with a 2 or 5 liter hydraulic accumulator, designed to supply clean water that does not contain abrasive particles and fibrous inclusions from shallow wells, wells and other water supply sources in automatic mode (turning on and off as the consumer consumes water). The stations are equipped with an electronic unit that controls the operation of the pump in terms of flow and minimum pressure (Pmin), and also protects the pump from operation in “dry running” mode and other emergency situations (drop in mains voltage, improper installation, etc.).

Advantages of the automatic adaptive station AQUAROBOT

• Automatically turns off when there is no water in the water supply system.
• Automatically switches off when the pump impeller becomes jammed.
• Operates stably when the mains voltage drops to 170 V.
• Automatically turns off if there is no air pressure in the accumulator.
• Automatically turns off when water leaks from the water supply system, if the flow rate is no more than 2 l/min.
• Adaptively maintains pressure in the water supply system, which significantly increases the service life of the pump.
• Operates stably at a critical suction depth of 8 meters.
• It automatically turns off if the station is incorrectly connected to the water supply source (for stable operation at low voltage or a critical suction depth of 8 meters, the water flow rate must be more than 2 l/min).

The principle of operation of the station is that when a water flow passes through the control unit at a speed above 2 l/min, or when the pressure drops below Pmin (1.5±0.3 bar), the pump turns on and pumps water continuously, creating pressure, the value of which depends on the pump parameters. When the water flow stops or its speed decreases to 2 l/min, the pump automatically turns off with a thirty-second delay.

AQUAROBOT ensures reliable shutdown of the station

• In low well productivity mode (“dry run”)
• If there is no air in the accumulator (no pressure)
• When the water flow is below 2 liters per minute (line leakage)
• In the mode of dynamic fluctuation of the water level in the well below 8 meters
• In case of improper installation of equipment and water supply lines

In the event of an emergency shutdown of the pumping station, it is necessary to eliminate the cause and restart it.

Attention. The use of the station in pressure boosting systems is not allowed if the pressure created by the pump, combined with the main pressure, is higher than or close to 6 bar.

Technical information

• Electrical network parameters – ~220 V ± 10%, 50 Hz
• Suction height – 8 m (for AQUAROBOT JET, JS) / 5 m (for AQUAROBOT QB)
• The operating temperature range of water is +1 ... +35°С, at an ambient temperature of +1 ... +40°С and air humidity no more than 70%.
• Connecting dimensions: 1" external thread x 1" internal thread
• Compressed air pressure in the hydraulic accumulator – 0.15 MPa (1.5 bar)
• Maximum permissible pressure in the system – 6 bar
• Pump activation pressure Pmin – 1.5±0.3 bar
• The minimum sensitivity of the flow sensor is 2 l/min.

Pressure and flow characteristics

Equipment in the online store

Adaptive automatic pumping station Unipump Aquarobot QB series is designed to supply clean water that does not contain abrasive particles and fibrous inclusions from shallow wells, wells and other water supply sources in automatic mode (turning on and off as the consumer consumes water). The station is equipped with an electronic unit that controls the operation of the pump in terms of flow and minimum pressure (Pmin), and also protects the pump from operation in “dry running” mode and other emergency situations (drop in mains voltage, incorrect installation, etc.). The pumping station is used for automatic water supply of houses, cottages and summer cottages, organization of irrigation systems, and increasing pressure in the water supply network.

The Unipump Aquarobot QB station is assembled on the basis surface pump QB series with cast iron body. Brass impeller ensures long and reliable operation for many years.

Principle of operation Unipump stations Aquarobot QB is that when a water flow passes through the control unit at a speed above 2 l/min, or when the pressure drops below Pmin (1.5±0.3 bar), the pump turns on and pumps water continuously, creating pressure in the system , the value of which depends on the pump parameters. When the water flow stops or its speed decreases to 2 l/min, the pump automatically turns off with a thirty-second delay.

The Aquarobot pumping station adapts to the conditions of a specific water supply system and creates comfortable conditions water use for you and your household appliances. Whenever technical problems The aqua robot will simply turn off until it is eliminated technical faults in your highway.

Advantages of the Unipump Aquarobot QB pumping station:

Automatically turns off when there is no water in the water supply system.

Automatically switches off when the pump impeller becomes jammed.

Operates stably when the mains voltage drops to 120 V.

Automatically turns off if there is no air pressure in the accumulator.

Automatically turns off when water leaks from the water supply system, if the flow rate is no more than 2 l/min.

Adaptively maintains pressure in the water supply system, which significantly increases the service life of the pump.

Operates stably at a critical suction depth of 8 meters.

Automatically turns off if the station is incorrectly connected to the water supply source.